The Correction key use the Correction key to do the following:
1Press the Correction key one time to return to the default value of the active setting.
2Press the Correction key two times to set the numeric display to 1.
3Press the Correction key three times to return to the top layer of the Scanner Operator Panel. When job templates are enabled in the Océ Settings Editor the top layer shows the job templates. When job templates are not enabled in the Océ Settings Editor, the top layer shows the ‘Custom’ section.
When ‘Automatic feed’ is selected for a single sheet job, this setting stays active.
Job interrupt only stays active for one job. You have to press the Job interrupt key before each new job you want to give interrupt priority.
The Scanner Operator Panel will automatically return to the top layer and the default settings after the time defined in the ‘Panel
54 | Océ TDS800 User Manual |
