DSM250 User’s Manual
6.12.4.2.1Sensor
You may select whether this channel is connected to a
6.12.4.2.2Engine Instance
Program this parameter to match the desired engine instance number of the flow rate and total fuel used for this channel. You can program this parameter to any value between 0 and 252.
NOTE: If the operating mode is set to “Differential Flow Rate”, then this parameter is unavailable for Channel #0.
6.12.4.2.3Engine Label
Each channel has a text label you can set to identify the load controlled by that channel (for example, “PORT ENGINE” or “COOLING WATER FLOW”). For each channel, set this to a value which describes the flow being monitored so that you can easily identify it in display devices.
6.12.4.2.4K-Factor
Program this parameter to match the
6.12.4.2.5Data Damping Period
You can configure a damping parameter to smooth the flow rate readings or make them more responsive. The data damping is configurable between
6.12.4.2.6Reset Total Volume Recorded
The FFM100 maintains the total volume recorded in EEPROM, so that it is maintained across power cycles. Select this menu entry to reset the total volume recorded to zero.
6.12.4.2.7Temperature Instance
Program this parameter to match the desired instance number of the temperature reading for this channel. You can program this parameter to any value between 0 and 252. The default value for this parameter is 0.
6.12.4.2.8Temperature Source
Program this parameter to match the desired source type of the temperature reading for this channel. The default value for this parameter is 129 (User Defined).
6.12.4.2.9Temperature Label
Program this parameter with a text string which identifies the particular temperature parameter being monitored by this channel. Maretron display products will display this label text when you are selecting data to display.
Page 102 | Revision 1.4.16a |
