DSM250 User’s Manual
6.22 Maretron SSC200 Configuration
This describes the configuration of the Maretron SSC200 firmware version 2.0.11. Nine configurable parameters for the Maretron SSC200 solid state compass may be configured using the Maretron DSM250 display. The Maretron SSC200 configuration menu can be seen in Figure 164 below.
Figure 164 – SSC200 Configuration Screen
6.22.1Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be performed by an advanced user. Typically advanced configuration is only done at installation and should not need to be done while at sea.
Figure 165 – SSC200 Advanced Configuration Screen
6.22.1.1Device Instance
This entry allows you to program the NMEA 2000 device instance for the unit. You usually will not need to modify the default value of “0” unless you have multiple units on the network.
Page 154 | Revision 1.4.16a |
