DSM250 User’s Manual

Enable

Disable

The desired option is selected using the Scroll Up and Scroll Down buttons, and then pressing the Enter button again.

8.3.13Operating Mode Anchored

See section 4.3.4 for a description of Operating Modes. For this Alert to be triggered when the vessel is in the Anchored state, this option must be set to Enabled. The options here are

Enable

Disable

The desired option is selected using the Scroll Up and Scroll Down buttons, and then pressing the Enter button again.

8.3.14Scope

Alerts may be constrained to be displayed only on the DSM250 where they are detected. In this case the Alert message is not sent out on the NMEA2000 bus, and other devices will not display the alert, or allow Accepting of Cancelling. The Scope does not affect the generation of Annunciator messages. The options here are

Local – the Alert messages are not transmitted

Global – the Alert messages are transmitted

The desired option is selected using the Scroll Up and Scroll Down buttons, and then pressing the Enter button again.

8.4Deleting an Alert

From the Alert Setup Menu, selected the menu item Delete Alert… .

Figure 272 – Deleting an Alert

Page 232

Revision 1.4.16a

Page 248
Image 248
Maretron DSM250-01 user manual Deleting an Alert, Operating Mode Anchored, Scope