®

Figure 66 – DSM150 Copy alarms settings from local display

After you select this menu item and press Enter, the alarm settings from this DSM250 unit will be copied to the selected remote DSM150/DSM250 unit.

6.8.3 Copy device selection from local display

Since it is normally desirable for all DSM150/DSM250 units on a network to display the same sensors, it is possible to copy the device selection settings from a DSM250 unit to a remotely located DSM150/DSM250. In this way, it is possible to make all device selection changes on a single DSM250 unit and then quickly and conveniently duplicate these new device selection settings on other DSM150/DSM250 units attached to the network. below shows this menu item highlighted.

Figure 67 – DSM250 Copy device selection from local display

After you select this menu item and press Enter, the device selection settings from this DSM250 unit will be copied to the selected remote DSM150/DSM250 unit.

Revision 1.4.16a

Page 77

Page 93
Image 93
Maretron DSM250-01 user manual Copy device selection from local display, DSM150 Copy alarms settings from local display