DSM250 User’s Manual
Figure 151 – RAA100 Custom Rudder Calibration Confirmation Screen
6.19.3.2Set to American Standard (240-33 ohm)
Use the option for rudders using a rudder angle sender with the standard American resistance range (240 ohms at full port 45°, 33 ohms at full starboard 45°).
6.19.3.3Set to European Standard (0-180 ohm)
Use this option for rudders using a rudder angle sender with the standard European resistance range (0 ohms at full port 45°, 180 ohms at full starboard 45°).
6.19.4Rudder Number
First, the rudder number must be configured. For a vessel with a single rudder, the number should be set to “0”. For a vessel with two rudders, the port rudder should be set to “0” and the starboard rudder should be set to “1”. Each rudder must have a rudder number that is different from all other rudders. A screenshot of rudder number configuration is shown in Figure 152 below.
In order to configure the rudder number, use the Scroll Up ( 
) or Scroll Down ( 
) keys to move the highlighted cursor to “Rudder Number:”, then press the Enter key ( 
) to move the cursor over to the rudder number value. Use the Scroll Up ( 
) or Scroll Down ( 
) keys to select the desired rudder number. Finally, press the Enter key ( 
) to confirm your selection and store the new rudder number within the RAA100.
Page 144 | Revision 1.4.16a |
