®

You can enable or disable the transmission of a PGN message, or set the frequency of transmission of the message by pressing the Enter key ( ) on the message to be configured. Options are:

Off – The PGN will not be transmitted

On – The PGN will be transmitted at its default NMEA2000 rate. 0.5s…5s – The PGN will be transmitted at the interval specified.

Select the required option using the Scroll Up and Scroll Down keys followed by the Enter key.

6.13.1.4Restore Factory Defaults

This option restores all settings on the device to their factory default state.

6.13.2Channel #0-5

This submenu contains configuration parameters for each of the six channels. These menus look different depending on whether the channel’s Function has been set to “Tank” or “Pressure/Vacuum”.

6.13.2.1Channel #0-5 (Tank)

This section describes the channel configuration menu when the channel ‘s Function has been set to “Tank” mode. The Channel #0-5 (Tank Mode) menu is too large to fit on a single screen, so it is shown in two separate screenshots below.

Figure 101 – FPM100 Channel #0 First Configuration Screen (Tank Mode)

Revision 1.4.16a

Page 109

Page 125
Image 125
Maretron DSM250-01 user manual Channel #0-5 Tank