DSM250 User’s Manual

change the value to the desired tank capacity value, and finally, press the Accept key to confirm your selection.

Figure 202 – Configuring the Tank Capacity

After you have pressed the Accept key, a confirmation screen will appear that warns you that the fluid remaining measurement will change as a result of this change. Press the Accept key to accept the change and store the new tank capacity value within the TLM100, or Press the Cancel Key to cancel the change and leave the old tank capacity programmed into the TLM100.

Figure 203 – Tank Capacity Change Confirmation Screen

6.24.4Tank Levels Calibration

In order for the TLM100 to indicate an accurate tank level, it must know the geometry of the tank. There are two methods of calibrating the tank level sender:

Custom Calibration – use for non-rectangular tanks (also, most accurate in any case, but requires more effort)

Rectangular Tank – By inputting some dimensions of a rectangular tank, the TLM100 is able to interpolate the volume of liquid from the distance to the surface.

Page 178

Revision 1.4.16a

Page 194
Image 194
Maretron DSM250-01 user manual Tank Levels Calibration