Maretron DSM250-01 user manual Switch/Breaker Display, Tank Gauge Display

DSM250 User’s Manual

Figure 248 – Tank Gauge Display

7.14 Switch/Breaker Display

The DSM250 is capable of controlling loads controlled by a Maretron DCR100 DC Relay, a Carling OctoPlex AC Box or DC Box, or other NMEA 2000® load controller which uses NMEA Command of the 127501 Binary Switch Bank Status PGN for control.

The display may be set up in several different configurations:

•Single-Indicator Light – this creates a single switch/breaker

•2 rows – this creates four rows of single switches/breakers

•3 rows – this creates three rows of single switches/breakers

•4 rows – this creates four rows of single switches/breakers

•2 rows, 2 columns – this creates two rows by two columns of a single switch/breaker

Figure 249 Below shows a Favorite Screens Setup screen with a single window configured with the “4 rows” configuration.

Figure 249 – Configuration of Switch/Breaker Display

Page 208 Revision 1.4.16a