Maretron DSM250-01 Fuel Fresh Water Waste Water Live Well Oil Black Water, 13.2.2.1Function

®

Fuel –

Fresh Water –

Waste Water –

Live Well –

Oil –

Black Water –

Reserved-1..Reserved-7– These values may be used when the contents of the tank does not fit into one of the categories above.

6.13.2.1.9Data Damping Period

If the channel’s Function is set to Tank, the default data damping period is 16.0 seconds. If the channel’s Function is set to Pressure/Vacuum, the default data damping period is 3.0 seconds.

6.13.2.2Channel #0-5 (Pressure/Vacuum)

This section describes the channel configuration menu when the channel ‘s Function has been set to “Pressure/Vacuum” mode. The Channel #0-5 (Pressure/Vacuum Mode) menu is shown below.

6.13.2.2.1Function

You can set the channel’s Function to “Disabled”, “Tank”, or “Pressure/Vacuum”. This section of the manual assumes that the channel’s function has been set to “Pressure/Vacuum”.

6.13.2.2.2Instance

This entry sets the instance number to be used in the Pressure message. This entry may be set to ay value between 0 and 252.

6.13.2.2.3Label

A label may be assigned to each channel of the FPM100 as an aid to identifying the pressure that is being displayed. Typically this label will describe the function or location of the pressure sensor.

Revision 1.4.16a Page 115