DSM250 User’s Manual
6.27 Maretron TMP100 Configuration
Maretron Temperature Modules (TMP100) may be configured using the DSM250. This describes the configuration of the Maretron TMP100 firmware version 1.1.1. The top level of the TMP100 configuration menu is shown below.
Figure 212 – TMP100 Configuration Screen
6.27.1Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be performed by an advanced user. Typically advanced configuration is only done at installation and should not need to be done while at sea.
Figure 213 – TMP100 Advanced Configuration Screen
6.27.1.1Device Instance
This entry allows you to program the NMEA 2000 device instance for the unit. You usually will not need to modify the default value of “0” unless you have multiple units on the network.
Page 184 | Revision 1.4.16a |
