DSM250 User’s Manual
6.18.1Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be performed by an advanced user. Typically advanced configuration is only done at installation and should not need to be done while at sea.
Figure 141 – NBE100 Advanced Configuration Screen
6.18.1.1Device Instance
This entry allows you to program the NMEA 2000 device instance for the unit. You usually will not need to modify the default value of “0” unless you have multiple units on the network.
6.18.1.2Installation Description
This entry allows you to modify the NMEA 2000 installation description text strings. You can enter any information you like here, such as the date the unit was installed, or the location in which it was installed, for later reference. Tools such as Maretron N2KAnalyzer allow you to view these values later.
6.18.1.3Restore Factory Defaults
This option restores all settings on the device to their factory default state.
6.19 Maretron RAA100 Configuration
This describes the configuration of the Maretron RAA100 firmware version 1.4.9.
Maretron RAA100 rudder angle adapters on the network may be configured using the DSM250. The RAA100 configuration menu is shown in Figure 142 below.
Page 138 | Revision 1.4.16a |
