DSM250 User’s Manual
6.20.3Instance
From here the instance used in the data message may be set.
6.20.4Channel Configuration
To configure an individual channel, use the Scroll Up and Scroll Down buttons to highlight the channel, and then press Enter. The following screen will be displayed.
Figure 159 – RIM100 Channel Configuration Screen
6.20.4.1Mode
Each Channel may be enabled or disabled. Valid Modes are:
Disable – the channel is not being used
Enable– the channel is being used
Select the required option using the Scroll Up and Scroll Down keys followed by the Enter key.
6.20.4.2Label
A label may be assigned to a channel as an aid to identifying the channel over the network. Typically this label will describe the equipment to which the channel is connected.
See section 3.3.4 for details on how to enter a textual value.
Page 150 | Revision 1.4.16a |
