DSM250 User’s Manual
Figure 196 – Configuring the Operating Mode
6.23.8Gauge Resistance, + to Sender
If the desired operating mode is “NMEA 2000 & Analog Gauge”, the two gauge resistances must be programmed (please refer to the TLA100 User’s Manual for details on how to perform these measurements). A screenshot of the + to sender gauge resistance configuration is shown in Figure 197 below. To program the + to sender gauge resistance, use the Scroll Up ( 
) or Scroll Down ( 
) keys to move the highlighted cursor over the “Gauge Resistance, + to Sender:” menu item. Then, press the Enter key ( 
) to move the highlight over the numerical resistance value. Use the “Increase” and “Decrease” keys to change the value to the measured resistance value, and finally, press the Enter key ( 
) to confirm your selection and store the value within the TLA100.
Figure 197 – Configuring the + to Sender Gauge Resistance
6.23.9Gauge Resistance, - to Sender
If the desired operating mode is “NMEA 2000 & Analog Gauge”, the two gauge resistances must be programmed (please refer to the TLA100 User’s Manual for details on how to perform these measurements). A screenshot of the - to sender gauge resistance configuration is shown in Figure 198 below.
Page 174 | Revision 1.4.16a |
