DSM250 User’s Manual
6.17 Maretron J2K100 Configuration
This describes the configuration of the Maretron J2K100 firmware version 1.0.7. The DSM250 is capable of configuring settings for the J1939 to NMEA 2000® Gateway (J2K100). A screenshot of the J2K100 configuration menu is shown in Figure 132 below.
Figure 132 – J2K100 Configuration Screen
6.17.1Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be performed by an advanced user. Typically advanced configuration is only done at installation and should not need to be done while at sea.
Figure 133 – J2K100 Advanced Configuration Screen
6.17.1.1Data Damping
In order to smooth the results viewed on a display, you may individually change the data damping period that the J2K100 uses when sending fuel rate and tachometer (engine RPM) information. The default is to use no damping (0.0 seconds). You may program the damping from none up to 5 seconds.
Page 132 | Revision 1.4.16a |
