®
To program the - to sender gauge resistance, use the Scroll Up ( 
) or Scroll Down ( 
) keys to move the highlighted cursor over the “Gauge Resistance, - to Sender:” menu item. Then, press the Enter key ( 
) to move the highlight over the numerical resistance value. Use the “Increase” and “Decrease” keys to change the value to the measured resistance value, and finally, press the Enter key ( 
) to confirm your selection and store the value within the TLA100.
Figure 198 – Configuring the - to Sender Gauge Resistance
Revision 1.4.16a | Page 175 |
