DSM250 User’s Manual
Figure 278 – Advanced Configuration
The following parameters may be set.
8.7.1 Remote Alert Audible
If Remote Alerts are enabled, and an active alert is received from another device on the bus, the DSM250 will respond by adding the Alert to its list of Active Alerts (section 8.1), and sounding the internal speaker. The sounding of the speaker may be disabled (i.e. only visual indications are displayed) by setting this parameter to Disable. The options here are
•Enable
•Disable
8.7.2 Flashing Screen
As an extra means to gain the operator’s attention to an Active Alert, the DSM250 may be set up to flash the entire screen between Red (for Alarms) or Yellow (for Warnings) and Black. The flashing may be disabled by setting this option to Disable. The options here are
•Enable
•Disable
8.8Restore Factory Defaults
The Alert parameters of the DSM250 may be restored to the factory defaults by pressing the
Enter button while this item is highlighted. The operator will be prompted to confirm this action before it taken.
Page 236 | Revision 1.4.16a |
