8Select the name of your printer and click .

Note

If you cannot find your printer name, click to refresh the list.

9Enter the network interface's MAC address, IP address, subnet mask, default gateway, and then click Apply.

Note

If you do not know the network interface's MAC address, print the machine's network information report. (See page 13.1 for "Printing a machine report")

10Click OK to confirm the settings.

11Click Exit to close the SetIP program.

Altitude adjustment

The print quality is affected by atmospheric pressure, which is determined by the height of the machine above sea level. The following information will guide you on how to set your machine to the best print quality or best quality of print.

Before you set the altitude value, find the altitude where you are using the machine.

Value

High 3

High 2

High 1

Normal

0

1Press Machine Setup on the control panel.

2Press Admin Setting.

3When the login message appears, enter password with number keypad and press OK. (Page 3.5)

4Press the General tab.

5Press Altitude Adjustment.

6Select appropriate option, and then click OK.

Note

Log in to the SyncThru™ Web Service as an administrator. (see page 13.9.)

Click Settings > Machine Settings > System > Setup > Altitude Adj.

Machine's basic settings

After installation is complete, you may want to set the machine's default settings. Check the next explanation if you would like to set or change values.

Setting the authentication password

To set your machine up or change the settings, you have to login. To change password, follow the next steps.

1Press Machine Setup on the control panel.

2Press Admin Setting.

3When the login message appears, enter password. Touch the password input area, then the question marks appears, use the number keypad on the control panel to enter the password. Then, press OK. (Factory setting:1111)

4Press the Setup tab > Security

5Press Change Admin. Password.

6Enter old and new password, and then confirm the new password.

7Press OK.

Setting the date and time

When you set the time and date, they are used in Delay fax and Delay Print, also they are printed on reports. If, however, they are not correct, you need to change it for correct time being.

1Press Machine Setup on the control panel.

2Press Admin Setting.

3.5 <Getting Started>

Page 33
Image 33
Samsung CLX-8540ND manual Altitude adjustment, Machines basic settings, Setting the authentication password