Teledyne gfc 7000ta operation manual Primary Setup Mode Features and Functions

Operating Instructions Model GFC7000TA Carbon Dioxide Analyzer

6.4. SETUP MODE

The SETUP mode contains a variety of choices that are used to configure the analyzer’s hardware and software features, perform diagnostic procedures, gather information on the instruments performance and configure or access data from the internal data acquisition system (DAS). For a visual representation of the software menu trees, refer to Appendix A. The areas access under the Setup mode are:

Table 6-4: Primary Setup Mode Features and Functions

MODE OR	TOUCHSCREEN	DESCRIPTION	MANUAL
FEATURE	BUTTON		SECTION
Analyzer	CFG	Lists key hardware and software configuration information	6.5
Configuration
		Used to set up and operate the AutoCal feature.
Auto Cal Feature	ACAL	Only appears if the analyzer has one of the internal valve	7.6
		options installed
Internal Data	DAS	Used to set up the DAS system and view recorded data	6.7
Acquisition (DAS)
Analog Output	RNGE	Used to configure the output signals generated by the
Reporting Range			6.8
		instruments Analog outputs.
Configuration
Calibration	PASS	Turns the calibration password feature ON/OFF	6.9
Password Security
Internal Clock	CLK	Used to Set or adjust the instrument’s internal clock	6.10
Configuration
Advanced SETUP	MORE	This button accesses the instruments secondary setup menu	See
Features			Table 6-5

Table 6-5:		Secondary Setup Mode Features and Functions
MODE OR FEATURE	TOUCHSCREEN		DESCRIPTION	MANUAL
	BUTTON			SECTION
External Communication			Used to set up and operate the analyzer’s various	6.11 &
		COMM	external I/O channels including RS-232; RS-485,
Channel Configuration				6.15
			modem communication and/or Ethernet access.
System Status Variables		VARS	Used to view various variables related to the	6.12
			instruments current operational status
			Used to access a variety of functions that are used to
System Diagnostic Features		DIAG	configure, test or diagnose problems with a variety of	6.13
			the analyzer’s basic systems
CO2 Concentration Alarms		ALRM	Used to activate the analyzer’s two gas concentration	6.14
			status alarms and set the alarm limits

NOTE

Any changes made to a variable during one of the following procedures is not

acknowledged by the instrument until the ENTR button is pressed

If EXIT is pressed before the ENTR button, the analyzer will beep alerting the user

that the newly entered value has been lost.

Teledyne Analytical Instruments 69