Teledyne gfc 7000ta operation manual Functional Check, Setup

Getting Started Model GFC7000TA Carbon Dioxide Analyzer

3.7.4. Functional Check

1.After the analyzer’s components has warmed up for at least 30 minutes, verify that the software properly supports any hardware options that were installed.

2.Check to make sure that the analyzer is functioning within allowable operating parameters. Appendix C includes a list of test functions viewable from the analyzer’s front panel as well as their expected values. These functions are also useful tools for diagnosing performance problems with your analyzer (Section11.1.2). The enclosed Final Test and Validation Data sheet (part number 04307) lists these values before the instrument left the factory.

To view the current values of these parameters press the following button sequence on the analyzer’s front panel. Remember until the unit has completed its warm up these parameters may not have stabilized.

SAMPLE

RANGE = 500.000 PPM

CO2 = XXX.X

	< TST TST > CAL	SETUP
		RANGE
		RANGE11
Toggle <TST TST> buttons		RANGE21
		O2 RANGE2
to scroll through list of
		STABIL
		MEAS
		REF
		MR RATIO	Refer to
		PRES
			Table 6-2 for
		SAMP FL
			definitions of
		SAMP TEMP
			these test
		BENCH TEMP	functions.
		WHEEL TEMP
		BOX TEMP
1 Only appears instrument is set		PHT DRIVE
for DUAL or AUTO reporting		SLOPE
range modes.		OFFSET
2 Only appears if O2 Sensor		TEST
Option is installed.		TIME

If your network is running a dynamic host configuration protocol (DHCP) software package, the Ethernet feature will automatically configure its interface with your LAN. (See Section 6.11.6.2). This configuration is useful for quickly getting an instrument up and running on a network. However, for permanent Ethernet connections, a static IP address should be used. (See Section 6.11.6.3).

Teledyne Analytical Instruments 36