Teledyne gfc 7000ta Conc ATIMER, 4, Translates to the following configuration Channel No

Operating Instructions Model GFC7000TA Carbon Dioxide Analyzer

6.7.2.3. Editing DAS Data Channels

DAS configuration is most conveniently done through the APICOM remote control program. The following list of key strokes shows how to edit using the front panel.

SAMPLE*	RANGE = 500.000 PPM	CO2 =X.XXX
< TST TST > CAL		SETUP

EXIT will return to the previous SAMPLE display.

Moves the

display up &

down the list of Data Channels

Inserts a new Data Channel into the list BEFORE the Channel currently being displayed

SETUP X.X		PRIMARY SETUP MENU
CFG	DAS RNGE PASS CLK MORE				EXIT
Main Data Acquisition Menu
SETUP X.X		DATA ACQUISITION
VIEW EDIT					EXIT
SAMPLE		ENTER SETUP PASS : 818
8	1	8		ENTR	EXIT
			Edit Data Channel Menu
SETUP X.X		0) CONC:	ATIMER,	1,	900	Exits to the Main
PREV NEXT		INS	DEL EDIT	PRNT	EXIT	Data Acquisition
						Menu
						Exports the
						configuration of all
						data channels to
Deletes The Data						RS-232 interface.
Channel currently
being displayed

Moves the display

between the

PROPERTIES for this

data channel.

SETUP X.X NAME:CONC
<SET SET> EDIT PRNT	EXIT

Exits returns to the

previous Menu

Allows to edit the channel name, see next key sequence.

Reports the configuration of current data channels to the RS-232 ports.

When editing the data channels, the top line of the display indicates some of the configuration parameters. For example, the display line:

0)CONC: ATIMER, 4, 800

translates to the following configuration:

Channel No.: 0

NAME: CONC

TRIGGER EVENT: ATIMER

PARAMETERS: Four parameters are included in this channel

EVENT: This channel is set up to record 800 data points.

Teledyne Analytical Instruments 78