Teledyne gfc 7000ta Property Default State Description Dhcp, Instrument, IP Address, Gateway IP

Operating Instructions			Model GFC7000TA Carbon Dioxide Analyzer
		Table 6-12: LAN/Internet Configuration Properties
	PROPERTY	DEFAULT STATE	DESCRIPTION
	DHCP	ON	This displays whether the DHCP is turned ON or OFF.
			Press EDIT and toggle ON for automatic configuration
			after first consulting network administrator. (
	INSTRUMENT		This string of four packets of 1 to 3 numbers each (e.g.
	IP ADDRESS		192.168.76.55.) is the address of the analyzer itself.
		0.0.0.0	Can only be edited when DHCP is set to OFF.
	GATEWAY IP		A string of numbers very similar to the Instrument IP
	ADDRESS		address (e.g. 192.168.76.1.) that is the address of the
			computer used by your LAN to access the Internet.
			Can only be edited when DHCP is set to OFF.
			Also a string of four packets of 1 to 3 numbers each (e.g.
			255.255.252.0) that identifies the LAN to which the device
	SUBNET MASK	0.0.0.0	is connected.
			All addressable devices and computers on a LAN must
			have the same subnet mask. Any transmissions sent to
			devices with different subnets are assumed to be outside
			of the LAN and are routed through the gateway computer
			onto the Internet.
	TCP PORT1	3000	This number defines the terminal control port by which the
			instrument is addressed by terminal emulation software,
			such as Internet or Teledyne’s APICOM.
	HOST NAME	T100	The name by which your analyzer will appear when
			addressed from other computers on the LAN or via the
			Internet. To change, see Section 6.11.6.3.
	1 Do not change the setting for this property unless instructed to by Teledyne Customer Service
	personnel.

NOTE

It is a good idea to check these settings the first time you power up your analyzer after it has been physically connected to the LAN/Internet to make sure that the DHCP has successfully downloaded the appropriate information from you network server(s).

If the gateway IP, instrument IP and the subnet mask are all zeroes (e.g.

“0.0.0.0”), the DCHP was not successful.

You may have to manually configure the analyzer’s Ethernet properties.

See your network administrator.

Teledyne Analytical Instruments 109