Agilent Technologies 1680, 1690 manual To remove the acquisition board, Do the following procedures

Chapter 6: Replacing Assemblies

1690A,AD-series disassembly/assembly

To remove the acquisition board

1Do the following procedures:

To remove the chassis from the sleeve

To remove the fascia

2Using a Torx T-10 screwdriver, remove one screw that secures the acquisition board to the deck.

3Using a Torx T-10 screwdriver, remove five screws that secure the probe shroud to the logic analyzer front panel.

4Slide the acquisition board out of the logic analyzer front panel.

Steps to remove the probe shroud from the acquisition board.

1Using a hex screwdriver, remove two hex nuts from the acquisition board trigger BNC connectors.

2Using a Torx T-10 screwdriver, remove five screws that secure the probe shroud to the acquisition board.

Reverse this procedure to install the acquisition board

If the probe shroud requires replacing, then the probe shroud label (part number 01690-94302) must also be ordered and installed on the replacement probe shroud.

136