Agilent Technologies 1680, 1690 manual To remove the PCI boards, 122

Chapter 6: Replacing Assemblies

1680A,AD-series disassembly/assembly

To remove the PCI boards

The following PCI boards are installed on the logic analyzer motherboard:

PCI IEEE 1394 board (slot 2, closest to the CD-ROM drive)

PCI display board (slot 3)

slot covers (slot 3 and slot 4)

1Do the procedure "To remove the chassis from the sleeve".

2Disconnect the cable from the board to be removed:

PCI IEEE 1394 board: IEEE 1394 cable

PCI display board: video cable

3Using a Torx T-10 screwdriver, remove one screw that secures each PCI board to the rear panel.

4Slide each board out the top of the chassis.

If the PCI display board is replaced, check to see if tape is covering the video cable connector on the board. If tape covers the connector, remove the tape before installing the PCI display board onto the motherboard.

5Reverse this procedure to install the PCI boards.

122