2 |
This TEST ALL command and report shows performance over the network between the initiating node and each responding node, at a rate comparable to what an application might experience. For further information, see the descriptions of the TEST and REPORT commands in Chapter 4.
Verify that all GEnet stations under test are included in the list, either as the initiating node or as a responding node. Also, all GEnet stations should report,
H3e8H Responses received,
H0H Responses with error, and
H0H No Responses. (A No Response will occur occasionally. But, on average, a No Response should occur no more than once with the TEST command above executed with 40,000 frames instead of 1,000 frames.)
Transcribe this report onto a clean copy of the Ethernet Network Test Data Sheet found in Appendix F, Forms. If you are testing a network with many nodes, you may need more than one data sheet.
6.When the TEST ALL command has completed and its results have been transcribed, gather the accumulated error log and LLC and MAC tallies from all GEnet stations by sending the following commands to each station. Transcribe all non±zero results to the Data Sheet.
$ rem <node> log
$ rem <node> tally l
7.Get the exception log and LLC and MAC tallies from the initiator by issuing the following commands:
$ log
$ tally l
Transcribe all non±zero results to the Data Sheet.
The LOG response from each node, including the initiator, should appear as follows:
REM$ <<<Exception Log>>>
REM$ Exception log empty
Make a notation on the Network Test Data Sheet that the log is empty, or record the values, if any, reported in the log response message.
The TALLY L response from each station should appear as follows:
REM> <<< Data | Link Tallies >>> |
|
|
|
|
| |
REM> Unreg | = 0000H | Lsap0 | = 0000H | LsapOfl | = 0000H | EthUnreg = 0000H | |
REM> MacErr | = 0000H | BufProb | = 0000H | UnrecPdu = 0000H | TstRcvd | = 0000H | |
REM> TstResp | = 0000H |
|
|
|
|
|
|
REM> |
|
|
|
|
|
|
|
REM> <<< MAC Tallies >>> |
|
|
|
|
|
| |
REM> SQEErr | = 0000H | MisdPack = 0000H | FrameErr | = 0000H | SuccOne | = 0000H | |
REM> CrcErr | = 0000H | RbufErr | = 0000H | LateCol | = 0000H | LostCarr = 0000H | |
REM> BsyCar | = 0000H | NoRtry | = 0647H | SuccMore = 0000H | FRtry | = 0000H | |
TCP/IP Ethernet Communications User's Manual ± January 1996 |
|
