HP 181A manual To Remove the Front Bezel

3

Chapter 3 Replacing Assemblies

To Remove the Front Bezel

To Remove the Front Bezel

1Remove the cover.

See the section titled “To Remove the Cover” in this chapter.

2Remove the bail handle (MP7) by rotating it to the vertical position and pull the ends outward as shown in Figure 3-3.

Figure 3-3. Handle Removal

3Remove the front rubber bumper (part of MP2), stretch a corner and then slide it off as shown in Figure 3-4.

Figure 3-4. Front Rubber Bumper Removal

4Disconnect the front bezel flat-ribbon cable (which is actually

A2 Display Board’s cable) from J6 of A1 Motherboard Assembly as shown in Figure 3-5.

3-6 Assembly-Level Service Guide