
3
Chapter 3 Replacing Assemblies
To Remove the A2 Display Board, Keypads, and Window
4Pull up on the top portion of the front bezel until the top portion of the display board is free from the top tabs.
5Pull down on the bottom portion of the front bezel until the display board is free from the bottom tabs.
If the board is still not free, insert a small
6Remove A2 Display Assembly from the front bezel.
NOTE | When installing A2 Display Board into the front bezel, pull up on the top | |
|
| portion of the front bezel and press display board into place. Make sure |
|
| that the board is positioned all the way into the bezel until the two tabs on |
|
| top and three on bottom are visible. |
|
|
|
7 | Now, remove the POWER key cap by gripping and pulling it. | |
|
|
|
NOTE | The cap must be removed to make installation of the A2 Display Board | |
|
| Assembly easier. |
|
|
|
8 | As shown in Figure | |
|
| Just pull them out of the bezel. |
9 | Remove the window (MP5), shown in Figure | |
|
| on the two top tabs and sliding the window forward. |