HP 5200 manual Action not Currently Available, On Tray, Custom, BAD Duplexer Connection

Control panel message	Description
<Date> <Time>	The printer has an internal clock that tracks
	the date and time. You are prompted to set
To change press	the correct date and time the first time you
To skip, press STOP	turn on the printer.

Access Denied MENUS LOCKED	The printer administrator has enabled the
	control-panel security mechanism. You
	cannot modify control-panel settings in this
	circumstance. The message disappears
	after a few seconds, and the printer returns
	to Ready or BUSY state.
ACTION NOT CURRENTLY AVAILABLE	You are trying to set duplex registration for
ON TRAY X	a tray that is configured for ANY SIZE or
alternates with	ANY CUSTOM. Duplex registration is not
	available when the tray size is set to either
Tray size cannot be ANY SIZE/ANY	of these settings.
CUSTOM

Recommended action

Press to change the date and time.

Press Stop to skip this step. You can set the date and time later by using the SYSTEM SETUP menu.

If the prompt appears each time you turn on the printer, the clock is not working correctly. Contact HP support.

Contact the printer administrator to change settings.

Change the size setting for the tray.

BAD DUPLEXER CONNECTION	The duplexer is not installed correctly.
alternates with
To continue turn off then on
Calibrating...	The printer is calibrating.
Canceling... <JOB NAME>	The printer is in the process of canceling a
	job. The message appears while the job is
	stopped, the paper path is flushed, and any
	remaining incoming data on the active data
	channel is received and discarded.

Turn the printer off and then on to continue.

No action necessary.

No action necessary.

Checking paper path	The engine is turning the rollers to check
	for possible jams.
Checking printer	The engine is performing an internal test.
CHOSEN PERSONALITY NOT	The printer encountered a request for a
AVAILABLE	personality that did not exist in the printer.
alternates with	The job is cancelled and no pages are
	printed.
To continue press
CLEANING DISK X% COMPLETE	The memory disk is being cleaned. This
alternates with	process might take up to an hour. During
	this time, no jobs can be printed.
DO NOT POWER OFF
Cleaning...	The printer is processing the cleaning page.
Clearing event log	This message appears while the event log
	is cleared. The printer then returns to the
	SERVICE menu.

No action necessary.

No action necessary.

1.Press to continue.

2.Try a different driver.

Do not turn off the printer. Wait for the process to complete.

The printer automatically restarts at the end of the cleaning process.

No action necessary.

No action necessary.

ENWW Control-panel messages 133