6.Press 
to highlight MANUAL SETTINGS, and then press 
.
7.Press 
to highlight SUBNET MASK, and then press 
.
8.Press the 
or 
arrow to increase or decrease the number for the first byte of the subnet mask.
9.Press 
to move to the next set of numbers. (Press 
to move to the previous set of numbers.)
10.Repeat steps 8 and 9 until the correct subnet mask is complete, and then press 
to save the subnet mask.
11.Press Menu to return to the Ready state.
Setting the default gateway
1.Press Menu.
2.Press 
to highlight CONFIGURE DEVICE, and then press 
.
3.Press 
to highlight I/O, and then press 
.
4.Press 
to highlight EMBEDDED JETDIRECT, and then press 
.
5.Press 
to highlight TCP/IP, and then press 
.
6.Press 
to highlight MANUAL SETTINGS, and then press 
.
7.Press 
to highlight DEFAULT GATEWAY, and then press 
.
8.Press the 
or 
arrow to increase or decrease the number for the first byte of the default gateway.
9.Press 
to move to the next set of numbers. (Press 
to move to the previous set of numbers.)
10.Repeat steps 8 and 9 until the correct default gateway is complete, and then press 
to save the default gateway.
11.Press Menu to return to the Ready state.
Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the following benefits:
●Decreases
●Prevents unauthorized users from printing to the printer
●Provides only pertinent information on the configuration page
●Allows the printer control panel to display
ENWW | Network configuration 53 |