Control panel message | Description | Recommended action | |
|
|
| |
RAM DISK IS WRITE PROTECTED | The file system is protected and no new | 1. To enable writing to the RAM disk | |
alternates with | files can be written to it. |
| memory, use HP Web Jetadmin to |
|
| turn off write protection. | |
Ready |
| 2. To remove this message from the | |
To clear press |
|
| display, press . |
|
|
| |
|
| See HP Web Jetadmin for more information. | |
|
|
| |
RAM DISK X Initializing | The new RAM disk installed in slot X is | No action necessary. | |
alternates with | initializing. |
|
|
|
|
| |
DO NOT POWER OFF |
|
|
|
|
|
| |
Receiving upgrade | A firmware upgrade is in progress. | Do not turn the printer off until the printer | |
|
| returns to Ready. | |
|
|
| |
Request accepted please wait | The printer has accepted a request to print | No action necessary. | |
| an internal page, but the current job must |
|
|
| finish printing before the internal page will |
|
|
| print. |
|
|
|
|
| |
Resend upgrade | The firmware upgrade was not successful. | Attempt the upgrade again. | |
|
|
| |
Restoring factory settings | The printer is restoring factory settings. | No action necessary. | |
|
|
| |
Restoring... | The printer is restoring settings. | No action necessary. | |
|
|
|
|
RFU LOAD ERROR | An error has occurred during a firmware | 1. | Reinstall the firmware. |
| upgrade. | 2. | If the problem persists, contact |
|
| ||
|
|
| HP Support. |
|
|
| |
Rotating motor | The printer is testing a motor. | Press Stop to stop this test. | |
alternates with |
|
|
|
To exit press STOP key |
|
|
|
|
|
| |
SANITIZING DISK X% COMPLETE | The memory disk is being sanitized. This | Do not turn off the printer. Wait for the | |
alternates with | process might take up to an hour. During | process to complete. | |
this time, no jobs can be printed. | The printer automatically restarts at the end | ||
DO NOT POWER OFF |
| ||
| of the sanitation process. | ||
|
|
| |
Setting saved | A menu selection has been saved. | No action necessary. | |
|
|
| |
SIZE MISMATCH IN TRAY XX | The tray is loaded with a media size that is | 1. Make sure the media guides are | |
alternates with | different than the size for which the tray is |
| adjusted correctly. |
configured. Printing can continue from other | 2. In the PAPER HANDLING menu, | ||
Ready | trays, but not from this one. | ||
|
| configure the tray for the correct size. | |
|
|
| |
Sleep mode on | The printer is in the sleep mode. Any button | No action necessary. The printer | |
| press or the receipt of data clears sleep | automatically exits sleep mode. | |
| mode. |
|
|
|
|
| |
STANDARD TOP BIN FULL | The output bin is full. Printing cannot | Empty the output bin. Printing resumes | |
alternates with | continue. | automatically. | |
|
|
| |
Remove all paper from bin |
|
|
|
|
|
| |
Tray X <TYPE> <SIZE> | The printer is reporting the current | No action necessary. | |
| configuration of tray X. |
|
|
|
|
|
|
138 Chapter 7 Problem solving | ENWW |
