HP 5961-0509 manual EC ID Secondary Symbol Set Command, 6PCL Font Selection

Symbol Set Command

The Symbol Set command identifies the specific set of symbols in a font. “Symbols” are the alphanumeric, punctuation, or any other printable characters or symbols which may be included.

EC ( ID Primary Symbol Set Command

ID = Symbol Set ID value (see Appendix C in the PCL 5

Comparison Guide)

EC ) ID Secondary Symbol Set Command

			ID = Symbol Set ID value (see Appendix C in the PCL 5
			Comparison Guide).
	Default	=	8U
	Range	=	N/A
	If the specified symbol set does not exist, Roman-8 is selected
	(However, the specified symbol set is written into the font select
	table.)
Notes	The factory default primary and secondary symbol set is Roman-8.
	However, you may select a user default symbol set from the printer
	control panel (see the printer User’s Manual).

If the font is a scalable typeface, symbol set is determined from the values contained in the printer’s font selection table. To specify a different symbol set, send a symbol set selection command prior to the Font Selection ID command. (Also see “Font Selection by ID Command,” later in this chapter.)

8-6PCL Font Selection EN