HP 5961-0509 manual EA, Edge Rectangle Absolute, Any two diagonally opposite corners

EA, Edge Rectangle Absolute

This command defines and outlines a rectangle using absolute coordinates. Use EA when drawing charts or schematic diagrams that require rectangles.

EA X,Y[;]

	Parameter	Format	Functional Range	Default
	X,Y coordinates	current units	-230to 230 - 1	no default
	The EA command defines and edges a rectangle using absolute
	coordinates and the current pen, line type and line attributes. The
	EA command performs an automatic pen down. When the command
	execution is complete, the original pen location and up/down status
	are restored.
	z X,Y Coordinates — Specify the opposite corner of the rectangle
	from the current pen location. The current pen location is the
	starting point of the rectangle. Coordinates are interpreted in
	current units: as user-units when scaling is on; as plotter units
	when scaling is off.
Note	The following illustration shows the current pen location in the lower
	left corner and the command’s X,Y coordinates in the upper-right
	corner. Depending on the coordinate values, the points can be in
	any two diagonally opposite corners.

EN EA, Edge Rectangle Absolute 21-17