HP 5961-0509 Left Offset Registration Command, ? & l # U, = The number of decipoints 1/720 inch

Left Offset Registration Command

The Left (long-edge) Offset Registration command designates the position of the logical page across the width (short side) of the physical page. This command can be used to adjust the text position on the page to allow additional room for the page binding.

?& l # U

		#	= The number of decipoints (1/720 inch)
	Default	=	0
	Range	=	–32767 to 32767
	The value (#) is a signed number valid to 2 decimal places. The units
	are decipoints. Positive values cause the logical page, regardless of
	orientation, to move right along the width of the physical page, except
	on the back side (duplex print) of sheets printed in long-edge binding
	duplex mode, where positive values cause it to move left (refer to
	Figure 4-4 and Figure 4-5).
	Negative values cause the logical page, regardless of orientation,
	to move left along the width of the physical page, except on the back
	side of sheets printed in long-edge binding duplex mode, where
	negative values cause it to move right (refer to Figure 4-4 and
	Figure 4-5).
Notes	The +/– value is absolute with respect to the default position of the
	logical page along the width of the physical page. It is not relative to
	the present location.

The registration commands may cause data loss by moving the logical page outside the printable area.

This command has the same effect regardless of orientation.

This command can be used in both simplex and duplex modes.

EN Left Offset Registration Command 4-7