HP 5961-0509 manual PA2300,2500FT3, 75,45, Hatching--parallel lines, with 75 plu, Lines tilted at

Table 21-6 Example: Filling Wedges and Circles (continued)

PA2300,2500;FT3, 75,45;	Specify absolute plotting and move to
	(2300,2500). Select fill type number 3
	(hatching--parallel lines), with 75 plu
	between hatching lines, and hatching
	lines tilted at 45°.
WG600,90,180;	Fill a wedge with the current fill type;
	use a radius of 600 plu, a start angle
	of 90°, and a sweep angle of 180°.
FT1,0,0;WG600, 270,60;	Specify a fill type of solid black and fill
	a wedge using the same center and
	radius as the previous wedge. Start
	the wedge at 270° with a sweep of
	60°.
FT4,60,45;WG600,	Specify fill type number 4
330,120;	(cross-hatching) with 60 plu between
	lines and the lines tilted at 45°. Fill a
	wedge using the same center and
	radius as the previous two wedges.
	Start the wedge at 330° with a sweep
	of 120°.
PA3500,2500;	Select absolute plotting and move
WG400,0,360;	to (3500,2500). Create a filled circle
	using the current fill type (cross-
	hatching), specifying a start angle
	of 0° and a 360° sweep.
PA4500,2500;FT;	Move to (4500,2500), select a solid
WG400,0,360;	fill, and fill a 360° wedge (circle).
?%0A	Enter the PCL mode.
?E	Send a reset to end the job and eject
	the page.

EN Drawing Wedges 21-9