HP 5961-0509 manual Attribute Kind Value Description, 22-16The Line and Fill Attributes Group

There are three line attributes: line ends, line joins, and the miter limit.

The LA command parameters are used in pairs: the first parameter, kind, selects a line attribute, and the second parameter, value, defines the appearance of that attribute. The printer uses the current line attributes when the optional parameter pairs are omitted.

zNo Parameters — Defaults the line attributes to butt ends, mitered joins, and a miter limit of 5. Equivalent to (LA1,1,2,1,3,5).

zKind— Specifies the line attribute for which you are setting a value. Attributes and kind parameter values are listed in the following table.

zValue— Defines the characteristics of the attribute specified by the kind parameter. The available values are listed in the following table and described under each attribute.

Table 22-8

Attribute	Kind	Value	Description
Line Ends*	1	1	Butt (default)
		2	Square
		3	Triangular
		4	Round
Line Joins*	2	1	Mitered (default)
		2	Mitered/beveled
		3	Triangular
		4	Round
		5	Beveled
		6	No join applied
Miter Limit	3	**	5 (default, refer to description
			under Miter Limit)

*Lines with a width of 0.35 mm or less always have butt caps and no join, regardless of the current attribute setting.

**Full range is 1 to 32,767, but values less than 1 are automatically set to 1.

22-16The Line and Fill Attributes Group EN