Figure 22-17Line Type Patterns and Pattern Percentages

zPattern Length- Specifies the length of one complete line pattern, either as a percentage of the diagonal distance between the scaling points P1 and P2 or in millimeters (see mode below). You must specify a length greater than zero or the printer ignores the command. If you do not specify a length, the printer uses the last value specified.

zMode- Specifies how the values of the pattern length parameter are interpreted. If you do not specify a mode, the printer uses the last value specified. Values other than 0 or 1 invalidate the command.

z0 - Relative mode. Interprets the pattern length parameter as a percentage of the diagonal distance between P1 and P2.

zWhen specified as a percentage, the pattern length changes along with changes in P1 and P2.

22-26The Line and Fill Attributes Group

EN

Page 590
Image 590
HP 5961-0509 manual 17Line Type Patterns and Pattern Percentages, 22-26The Line and Fill Attributes Group