HP 5961-0509 Horizontal Rectangle Size Decipoints Command, Measure is set to 600 units-per-inch

Horizontal Rectangle Size (Decipoints) Command

This Horizontal Rectangle Size command specifies the rectangle width in decipoints.

EC * c # H

#=Number of decipoints (1/720 inch)

Default	=	0
Range	=	0 - 32767 (valid to 4 decimal places)

The printer converts the specified width to printer dots by rounding up to an integral number of dots. For example, 5 decipoints, which corresponds to 2.08 dots in 300 dpi mode, is converted to 3 dots.

Horizontal Rectangle Size (PCL Units) Command

This Horizontal Rectangle Size command specifies the rectangle width in PCL Units.

EC * c # A

		# =Number of PCL Units
	Default	=	0
	Range	=	0 - 32767
	For example, if the unit of measure is set to 300 units-per-inch, to
	specify a two-inch wide rectangle, send the command: E *c600A
			C
	The same command specifies a one-inch wide rectangle if the unit of
	measure is set to 600 units-per-inch.
Note	The number of units-per-inch used in PCL dot moves is determined
	by the current setting of the Unit of Measure command (see “Unit of
	Measure Command” in Chapter 4).

EN Horizontal Rectangle Size (Decipoints) Command 14-3