HP 5961-0509 manual Top Offset Registration Command, ? & l # Z, 8PCL Job Control Commands

Top Offset Registration Command

The Top (short-edge) Offset Registration command designates the position of the logical page along the length (long side) of the physical page.

?& l # Z

		#	= The number of decipoints (1/720 inch)
	Default	=	0
	Range	=	–32767 to 32767
	The value (#) is a signed number valid to 2 decimal places. The units
	are decipoints. Positive values cause the logical page, regardless of
	orientation, to move down along the length of the physical page,
	except on the backside of sheets printed in short-edge binding duplex
	mode, where positive values cause it to move up (refer to Figure 4-4
	and Figure 4-5).
	Negative values cause the logical page, regardless of orientation,
	to move up, along the length of the physical page, except on the
	backside of sheets printed in short-edge binding duplex mode, where
	negative values cause it to move down (refer to Figure 4-4 and
	Figure 4-5).
Notes	The +/– value is absolute with respect to the default position of the
	logical page along the length of the physical page. It is not relative to
	the current location of the logical page.

The registration command may cause data loss by moving the logical page outside the printable area.

This command has the same effect regardless of orientation.

This command can be used in both simplex and duplex modes.

4-8PCL Job Control Commands EN