HP 5961-0509 manual Center point of the above circle is located at 0,0, Example

Table 21-26 Example: Filling then Edging vs. Edging then Filling Chart (continued)

?%0A

?E

Enter the PCL mode.

Send a reset to end the job and eject the page.

	Figure 21-28
	The center point of the above circle is located at (0,0).
Note	When transparency mode (TR command) is opaque, filling then
	edging an object may produce different results from edging and then
	filling. This is especially true when large pen widths are used. The
	following example illustrates this.

Table 21-27 Example:

?E	Reset the printer.
?%0B	Enter HP-GL/2 mode.
IN;	Initialize HP-GL/2 mode.
SP1;	Select printer logical pen number 1.
TR0;	Set transparency mode OFF (opaque)
PU4000,6000;	Position pen.

EN WG, Fill Wedge 21-49