Vertical Rectangle Size (Decipoints) Command

This Vertical Rectangle Size command specifies the rectangle height in decipoints.

EC * c # V

#=Number of decipoints (1/720 inch)

Default

=

0

Range

=

0 - 32767 valid to 4 decimal places

The printer converts the specified width to printer dots by rounding up to an integral number of dots. For example, 5 decipoints, which corresponds to 2.08 dots in 300 dpi mode, is converted to 3 dots.

Vertical Rectangle Size (PCL Units) Command

This Vertical Rectangle Size command specifies the rectangle height in PCL Units.

EC * c # B</BLD

 

 

# =Number of PCL Units

 

Default

=

0

 

Range

=

0 - 32767

 

For example, if the unit of measure is set to 300 units-per-inch, to

 

specify a two-inch high rectangle, send the command: E *c600A

 

 

 

C

 

The same command specifies a one-inch high rectangle if the unit

 

of measure is set to 600 units-per-inch.

 

 

Note

The number of units-per-inch used in PCL dot moves is determined

 

by the current setting of the Unit of Measure command (see “Unit of

 

Measure Command” in Chapter 4).

 

 

 

 

14-4PCL Rectangular Area Fill Graphics

EN

Page 294
Image 294
HP 5961-0509 manual Vertical Rectangle Size Decipoints Command, Vertical Rectangle Size PCL Units Command