HP 5961-0509 manual LT, Line Type, LT99 Functional Parameter Format Range Default

LT, Line Type

This command specifies the line pattern to be used when drawing lines. Use LT to vary lines and enhance your plot. Note that the ends of dashed line segments in a line pattern are affected by current line attributes (refer to the LA command earlier in this chapter).

LT line type[,pattern length[,mode;]]

or

LT [;]

or

LT99 [;]

		Functional
Parameter	Format	Range	Default
line type	clamped integer	-8 to 8	solid line
		99	restores previous
			line type
pattern length	clamped real	>0	4% of the distance
			between P1 and P2
mode	clamped integer	0 or 1	0 (relative)

The LT command applies to lines drawn by the AA, AR, AT, CI, EA, EP, ER, EW, FP, PA, PD, PE, PR, RA, RR, RT, and WG commands. Line types are drawn using the current line attributes set by the Line Attribute (LA) command. For example, if you have used LA to specify rounded ends, the printer draws each dash in a dashed line pattern with rounded ends.

zNo Parameters- Defaults the line type to solid and saves the previous line type, pattern length, and any unused portion of the pattern (residue).

zLine Type- Subsequent lines are drawn with the corresponding line pattern. Line patterns can be of fixed or adaptive type.

22-22The Line and Fill Attributes Group EN