HP 5961-0509 manual Source Transparency Mode Command, End of Page Data, 13-6The PCL Print Model

Table 13-1 (continued)

•

•

End of Page Data

Source Transparency Mode Command

The Select Source Transparency Mode command sets the source image’s transparency mode to transparent or opaque.

EC * v # N

#=0 - Transparent 1 - Opaque

Default	=	0
Range	=	0, 1 (other values cause the command to be ignored)

With a transparency mode of “0” (transparent), the white regions of the source image are not be copied onto the destination. With a transparency mode of “1” (opaque), the white pixels in the source are applied directly onto the destination.

Refer to the preceding definitions and the discussion of Figure 13-3 for an explanation of the effects of transparency.

13-6The PCL Print Model EN