HP 5961-0509 manual RR, Fill Rectangle Relative, 21-42The Polygon Group

Table 21-23 (continued)

FT, Fill Type

LT, Line Type

RF, Raster Fill Definition

The Line and Fill Attributes Group

RR, Fill Rectangle Relative

This command defines and fills a rectangle using relative coordinates. Use RR to fill rectangular shapes in drawings. (To outline a rectangle using relative coordinates, use the ER command.)

RRX,Y[;]

Parameter	Format	Functional Range	Default
X,Y increments	current units	-230to 230 - 1	no
			default

	The RR command defines and fills a rectangle using the current pen,
	the current line and fill types, and relative coordinates. The RR
	command includes an automatic pen down. After the command is
	executed, the original pen location and up/down status are restored.
	z X,Y Increments — Specify the corner of the rectangle that is
	diagonally opposite from the current pen location, which is the
	starting point of the rectangle. Coordinates are interpreted in
	current units: as user-units when scaling is on; as plotter units
	when scaling is off.
Note	The following illustration shows the current pen location in the
	lower-left corner and the command’s X,Y increments in the
	upper-right corner. However, these points can be in any two
	opposite corners depending on the coordinates used.

21-42The Polygon Group EN