HP 5961-0509 manual Set Status Readback Location Unit Command, Location Type Unit

Set Status Readback Location Unit Command

The Set Location Unit command sets the status location unit to the specified value. Location unit is used in conjunction with the location type to identify an entity location for a status request (Inquire Status Readback Entity command). Note that the unit value is interpreted differently, depending on the location type specified.

EC * s # U

Table 16-4 Set Status Readback Location Unit Command

Location		Location
Type		Unit
0	#	=	*	Invalid location
1		=	*	Currently selected
2		=	*	All Locations
3		=	0	All internal
4		=	0	All downloaded
		=	1	Temporary downloaded
		=	2	Permanent downloaded
5		=	0	All cartridges
		=	1	Highest priority cartridge
			￿	￿
			n	Lowest priority cartridge
7		=	0	All SIMMs
		=	1	Highest priority SIMM
			￿	￿
			n	Lowest priority SIMM

Default	=	0
Range	=	0 through n, where n is printer dependent. Refer to
		the PCL 5 Comparison Guide.

* - For location type values 0, 1 and 2, the unit value is ignored; it may be any value.

EN Set Status Readback Location Unit Command 16-9