Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show mgcp
VR-742
Cisco IOS Voice, Video, Fax Command Reference
show mgcp
To display Media Gateway Control Protocol (MGCP) configuration information, use the show mgcp
command in EXEC mode.
show mgcp
Defaults No defaults
Command Modes EXEC
Command History
Examples The following displays an example of the command format and output for show mgcp.
Router# show mgcp
MGCP Admin State ACTIVE, Oper State ACTIVE - Cause Code NONE
MGCP call-agent: 192.168.10.10 2302 Initial protocol service is MGCP
mgcp block-newcalls DISABLED
MGCP dtmf-relay disabled for all codec types
MGCP modem passthru: CA
MGCP request timeout 500, MGCP request retries 3
MGCP gateway port: 2427, MGCP maximum waiting delay 3000
MGCP restart delay 5, MGCP vad DISABLED
MGCP sdp simple DISABLED, MGCP cisco fgdos DISABLED
MGCP codec type g711ulaw, MGCP packetization period 20
MGCP JB threshold lwm 30, MGCP JB threshold hwm 150
MGCP LAT threshold lwm 150, MGCP LAT threshold hwm 300
MGCP PL threshold lwm 1000, MGCP PL threshold hwm 10000
MGCP playout mode is adaptive 60, 4, 200 in msec
MGCP IP ToS low delay disabled, MGCP IP ToS high throughput disabled
MGCP IP ToS high reliability disabled, MGCP IP ToS low cost disabled
MGCP IP precedence 3, MGCP default package: trunk-package
MGCP supported packages: gm-package dtmf-package trunk-package rtp-package
as-packagescript-package
Release Modification
12.1(1)T This command was introduced for the Cisco AS5300 universal
access server.
12.1(3)T Output was updated to show additional gateway and platform
information.