Cisco IOS Voice, Video, and Fax Commands: R Through Sh
show call active
Table 27 show call active Field Descriptions (continued)
Field | Description |
|
|
GapFillWithPrediction | Duration of the voice signal played out with signal synthesized from |
| parameters, or samples of data preceding in time, because voice data was |
| lost or not received in time from the voice gateway for this call. Examples |
| of such pullout are |
| G.729 and G.723.1 compression algorithms. |
|
|
GapFillWithSilence | Duration of a voice signal replaced with silence because voice data was |
| lost or not received in time for this call. |
|
|
HiWaterPlayoutDelay | |
|
|
Index | Dial peer identification number. |
|
|
InfoActivity | Active information transfer activity state for this call. |
|
|
InfoType | Information type for this call, for example, voice or fax. |
|
|
InSignalLevel | Active input signal level from the telephony interface used by this call. |
|
|
Last Buffer Drain/Fill | Time since the last jitter buffer drain or fill event, in seconds. |
Event |
|
|
|
LogicalIfIndex | Index number of the logical interface for this call. |
|
|
LoWaterPlayoutDelay | Low water mark Voice Playout FIFO Delay during this call. |
|
|
Modem passthrough | Indicates that this is a modem |
signaling method in use | events |
| signaling codec upspeed. The upspeed method is the method used to |
| dynamically change the codec type and speed to meet network |
| conditions. This means that you might move to a faster codec when you |
| have both voice and data calls and then slow down when there is only |
| voice traffic. |
|
|
NoiseLevel | Active noise level for this call. |
|
|
OnTimeRvPlayout | Duration of voice playout from data received on time for this call. Derive |
| the Total Voice Playout Duration for Active Voice by adding the |
| OnTimeRvPlayout value to the GapFill values. |
|
|
OutSignalLevel | Active output signal level to the telephony interface used by this call. |
|
|
PeerAddress | Destination pattern or number associated with this peer. |
|
|
PeerId | ID value of the peer table entry to which this call was made. |
|
|
PeerIfIndex | Voice port index number for this peer. For ISDN media, this would be the |
| index number of the B channel used for this call. |
|
|
PeerSubAddress | Subaddress when this call is connected. |
|
|
Percent Packet Loss | Total percent packet loss. |
|
|
ReceiveBytes | Number of bytes received by the peer during this call. |
|
|
ReceiveDelay | Average Playout FIFO Delay plus the Decoder Delay during this voice |
| call. |
|
|
ReceivePackets | Number of packets received by this peer during this call. |
|
|
RemoteIPAddress | Remote system IP address for the VoIP call. |
|
|
RemoteUDPPort | Remote system UDP listener port to which voice packets are sent. |
|
|
Cisco IOS Voice, Video, Fax Command Reference
