Cisco Systems VR-561 manual Ring, Default is Interface configuration, VR-576

Cisco IOS Voice, Video, and Fax Commands: R Through Sh

ring

ring

To set up a distinctive ring for your connected telephones, fax machines, or modems, use the ring command in interface configuration mode. To disable the specified distinctive ring, use the no form of this command.

ring cadence-number

no ring cadence-number

Syntax Description cadence-number Number from 0 through 2:

•Type 0 is a primary ringing cadence—default ringing cadence for the country your router is in.

•Type 1 is a distinctive ring—0.8 seconds on, 0.4 seconds off,

0.8seconds on, 0.4 seconds off.

•Type 2 is a distinctive ring—0.4 seconds on, 0.2 seconds off,

0.4seconds on, 0.2 seconds off, 0.8 seconds on, 4 seconds

off.

Defaults

Command Modes

Command History

The default is 0.

Interface configuration

Release	Modification
12.0(3)T	This command was introduced on the Cisco 800 series router.

Usage Guidelines This command applies to Cisco 800 series routers.

You can specify this command when creating a dial peer. This command will not work if it is not specified within the context of a dial peer. For information on creating a dial peer, refer to the Cisco 800 Series Routers Software Configuration Guide.

Examples	The following example specifies the type 1 distinctive ring:
	ring 1

Cisco IOS Voice, Video, Fax Command Reference

VR-576