Cisco Systems VR-561 manual Session protocol multicast, Session target ipv4, VR-606

Cisco IOS Voice, Video, and Fax Commands: R Through Sh

session protocol multicast

session protocol multicast

Syntax Description

Defaults

To set the session protocol as multicast, use the session protocol multicast command dial-peer configuration mode. To negate this command and return to the Cisco default session protocol, use the no version of this command.

session protocol multicast

no session protocol multicast

There are no keywords or arguments.

When this command is not implemented, the default session protocol is cisco.

Command Modes

Command History

Dial-peer configuration

Release	Modification
12.1(2)XH	This command was introduced on Cisco 2600 and Cisco 3600 series
	routers for the Cisco Hoot and Holler over IP application.
12.1(3)T	This command was integrated into the Cisco IOS Release 12.1(3)T.

Usage Guidelines

Examples

Use the session protocol multicast dial-peer configuration command for voice conferencing in a Hoot and Holler networking implementation. This command allows more than two ports to join the same session simultaneously. It is supported on Cisco 2600 and Cisco 3600 series routers.

The following example shows the use of the session protocol multicast dial-peer configuration command in context with its accompanying commands:

dial-peer voice 111 voip destination-pattern 111 session protocol multicast

session target ipv4:237.111.0.111:22222 ip precedence 5

codec g711ulaw

Related Commands	Command	Description
	session target ipv4	Assigns the session target for voice-multicasting dial peers.

Cisco IOS Voice, Video, Fax Command Reference

VR-606