Cisco Systems VR-561 manual Show call fallback cache ip-address, VR-666, Icpif

Cisco IOS Voice, Video, and Fax Commands: R Through Sh

show call fallback cache

show call fallback cache

To see the current Calculated Planning Impairment Factor (ICPIF) estimates for all IP addresses in cache, use the show call fallback cache command in EXEC mode.

show call fallback cache [ip-address]

Syntax Description	ip-address	(Optional) Specifies a specific IP address.
Defaults	This command is not configured by default.

Command Modes

Command History

EXEC

Release	Modification
12.1(3)T	This command was introduced on the Cisco 2600 series and
	Cisco 3600 series routers and on the Cisco MC3810 multiservice
	concentrator.

Usage Guidelines To clear all entries in the cache, use the clear call fallback cache command.

Examples	The following example displays output from the show call fallback cache command:
	Router#	show call fallback cache
	Probe	IP Address	Codec	Delay	Loss	ICPIF	Reject	Accept
	-----	----------	-----	-----	----	-----	------	------
	1	1.1.1.4	g729r8	40	00	0	9
	2	122.24.56.25	g729r8	14810	5	1	4
	2 active probes
	Field		Description
	-------		------------
	Probe		Probe number
	IP Address		IP Address to which the probe is sent
	Codec		Codec Type of the probe
	Delay		Delay in milliseconds that the probe incurred
	Loss		Loss	in % that the probe incurred
	ICPIF		Computed ICPIF value			for the probe
	Reject		Number of times that			calls of Codec Type <Codec>
			were	rejected to the		IP Address
	Accept		Number of times that			calls of Codec Type <Codec>
			were	accepted to the		IP Address
	active probes		Number of destinations being probed

Cisco IOS Voice, Video, Fax Command Reference

VR-666