Cisco Systems VR-561 manual Session target VoFR, Session target interface dlci, VR-610

Cisco IOS Voice, Video, and Fax Commands: R Through Sh

session target (VoFR)

session target (VoFR)

To specify a network-specific address for a specified VoFR dial peer, use the session target command in dial-peer configuration mode. To restore default values for this parameter, use the no form of this command.

Cisco 2600 and 3600 Series Routers Voice over Frame Relay Dial Peers

session target interface dlci [cid]

no session target

Cisco MC3810 Multiservice Concentrator Voice over Frame Relay Dial Peers

session target interface dlci [cid]

no session target

Cisco 7200 Series Routers Voice over Frame Relay Dial Peers

session target interface dlci

	no session target
Syntax Description	interface	Specifies the serial interface and interface number (slot number and
		port number) associated with this dial peer. For the range of valid
		interface numbers for the selected interface type, enter a ? character
		after the interface type.
	dlci	Specifies the data link connection identifier for this dial peer. The
		valid range is from 16 to 1007.
	cid	(Optional) Specifies the DLCI subchannel to be used for data on
		FRF.11 calls. A CID must be specified only when the session protocol
		is frf11-trunk. When the session protocol is cisco-switched, the CID
		is dynamically allocated. The valid range is from 4 to 255.
		Note By default, CID 4 is used for data; CID 5 is used for
		call-control. We recommend that you select CID values
		between 6 and 63 for voice traffic. If the CID is greater than
		63, the FRF.11 header will contain an extra byte of data.
Defaults	The default for this command is enabled with no IP address or domain name defined.
Command Modes	Dial-peer configuration

Cisco IOS Voice, Video, Fax Command Reference

VR-610